Xerox DocuPrint P1202 User Manual

Also see for DocuPrint P1202: Parts list Reference guide Reference guide Service manual

Xerox DocuPrint P1202 User Manual Manual pdf 13 page image

DocuPrint P1202 User Guide1-13E N G L I S HSoftware Utilities InstallationFor full details on the printer software, consult the Reference Guide on the DocuPrint P1202 CD-ROM.Installing the USB Port Driver(Windows 98)Installing the RCP and SM(Windows)The USB port driver must be installed in orderto print to the DocuPrint P1202 via a USBconnection. Currently, USB printing is onlyavailable through Windows 98.1 Insert the Xerox DocuPrint P1202 CD-ROM intoyour CD-ROM drive. If Windows automaticallyruns the CD-ROM, skip to Step 3.2 Select Run from the Start menu. Typed:\setup.exe on the command line (where “d” isyour CD-ROM drive letter), then click OK.3 Select the appropriate language, then select USBPort Driver.Installing the Xerox Font Manager(Windows)The Xerox Font Manager is a Windows-basedutility that allows you to install, load andmanage fonts on the DocuPrint P1202.1 Insert the Xerox DocuPrint P1202 CD-ROM intoyour CD-ROM drive. If Windows automaticallyruns the CD-ROM, skip to Step 3.2 For Windows 95/98/NT 4.0:Select Run from the Start menu. Typed:\setup.exe on the command line (where “d” isyour CD-ROM drive letter), then click OK.For Windows 3.1x:Open the Program Manager and select Run fromthe File menu. Type d:\setup16.exe on thecommand line (where “d” is your CD-ROM driveletter), then click OK.3 Select the appropriate language, then select theXerox Font Manager.The RCP (Remote Control Panel) and the SM(Status Monitor) software are Windows-basedprograms that allow the user to set defaultprinter values as well as monitor the status ofthe printer.These two utilities can only be used when theprinter is connected via the parallel interface.1 Insert the Xerox DocuPrint P1202 CD-ROM intoyour CD-ROM drive. If Windows automaticallyruns the CD-ROM, skip to Step 3.2 For Windows 95/98/NT 4.0:Select Run from the Start menu. Typed:\setup.exe on the command line (where “d” isyour CD-ROM drive letter), then click OK.For Windows 3.1x:Open the Program Manager and select Run fromthe File menu. Type d:\setup16.exe on thecommand line (where “d” is your CD-ROM driveletter), then click OK.3 Select the appropriate language.4 For Windows 3.1x, 95 and 98, select RCP andSM. For Windows NT 4.0, select RCP.