Xerox Nuvera 100 roduction Systems Paper Manual

Also see for Nuvera 100 EA: User guide User manual Brochure Product safety data sheet Operator's manual

Contents

Xerox Nuvera 100 roduction Systems Paper Manual Manual pdf 54 page image

Printing with tabs Xerox NuveraB-4 Paper GuidePrinting on tabbed stockProgramming a job with tabs incorporates many features and functions of the Xerox Nuvera.Jobs with tabbed stock must be set up according to the system’s finishing equipment. Refer tothe following sets of hints and tips when printing jobs with tabbed stock.For systems with a Multifunction Finisher (MFF)• Use only reverse collated tabs.• Load tabs with the last tab in a set on top. For 5-bank tabs, load tabs 5, 4, 3, 2, 1; 5 on top.• Load paper according to the labels on the feed trays with the tabs on the trail edge.• Program the feed trays.• Program the job to run N-1, face-up.• If printing on 8.5 x 11 inch tabs, set the properties for the tabs as single-sided ExceptionPages and set the image shift to 1/2 inch.• If using preprinted tabs, add them as Inserts.• If the job uses hole punched tabs and hole punched body stock, both stocks are loadedwith the punched edges leading.• The system assumes that tabs are right edge portrait or bottom edge landscape. If the jobis different, you may need to select [Rotate 180] for the entire job.• If using Build Job to program the tab job, select [Build Job Type: Contains Tab Stock orEnvelopes].• Tabs cannot be loaded in the Insertion Module.For systems with DS3500 / DS5000 or BFM type finishers• Use only forward collated tabs.• Load tabs with the first tab in a set on top. For 5-bank tabs, loads tabs 1, 2, 3, 4, 5, with 1 ontop.• Load paper according to the labels on the feed trays with tabs on the trail edge.• Program the feed trays.• Program the job to run 1-N, face-down.• If printing on 8.5 x 11 inch tabs, set the properties for the tabs as single-sided ExceptionPages and set the image shift to 1/2 inch.• If using preprinted tabs, add them as Inserts.• If the job uses hole punched tabs and hole punched body stock, both stocks are loadedwith the punched edges leading.• The system assumes that tabs are right edge portrait or bottom edge landscape. If the jobis different, you may need to select [Rotate 180] for the entire job.• If using Build Job to program the tab job, select [Build Job Type: Contains Tab Stock orEnvelopes].• Tabs can be loaded in the Insertion Module.