Xerox PHASER 3435 User Manual

Also see for Phaser 3435DN: Features Specifications Specification

Contents

Xerox PHASER 3435 User Manual Manual pdf 26 page image

4.2 <Network setup>Configuring TCP/IPYour printer can be set up with a variety of TCP/IP network information,such as an IP address, a subnet mask, a gateway, and DNS addresses.There are several ways in which your printer can be assigned a TCP/IPaddress, depending on your network.• Static addressing: A TCP/IP address is assigned manually by thesystem administrator.• Dynamic addressing via BOOTP/DHCP (default): A TCP/IP addressis assigned automatically by the server.NoteBefore configuring TCP/IP, you need to set the networkprotocol to TCP/IP.Static addressingTo enter a TCP/IP address from your printer’s control panel, take thefollowing steps:1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press OK when TCP/IP appears.3 Press the Up/down arrow buttons until Static appears and pressOK.4 Press OK when IP Address appears.5 Set the first byte between 0 and 255 using the Up/down arrowbuttons and press OK to move to the next byte.Repeat this to complete the address from the 1st byte to the 4thbyte.6 When you have finished, press OK.7 Repeat step 5 and 6 to configure the other TCP/IP parameters:subnet mask and gateway address.8 Press Start/Stop to return to Standby mode.Dynamic addressing (BOOTP/DHCP)To have a TCP/IP address assigned automatically by the server, take thefollowing step:1 Press Menu until Network appears on the bottom line of thedisplay.2 Press OK when TCP/IP appears.3 Press the Up/down arrow buttons until DHCP or BOOTP appearsand press OK.4 Press Start/Stop to return to Standby mode.Configuring EtherTalkEtherTalk is AppleTalk used in an Ethernet network. This protocol iswidely used in Macintosh network environments. To use EtherTalk, takethe following steps:1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press the Up/down arrow buttons until EtherTalk appears andpress OK.3 Press the Up/down arrow buttons until On appears and press OK.4 Press Start/Stop to return to Standby mode.Setting Ethernet speedYou can select the communication speed for Ethernet connections.1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press the Up/down arrow buttons until Ethernet Speed appearsand press OK.3 Press the Up/down arrow buttons until the speed you wantappears and press OK.4 Press Start/Stop to return to Standby mode.Restoring the network configurationYou can return the network configuration to its default settings.1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press the Up/down arrow buttons until Clear Setting appears andpress OK.3 Press OK when Yes appears to restore the network configuration.4 Power the printer off and back on.