Xerox Phaser 7300 Features Manual

Also see for Phaser 7300: Brochure & specs Support guide Specification Overview Troubleshooting guide

Xerox Phaser 7300 Features Manual Manual pdf 28 page image

Printer FeaturesPhaserÆ 7300 Color Printer 23Power saverThe printer enters a Power Saver low-energy consumption mode after a predefined period of time sinceits last activity. In this mode, most printer electrical systems are shut down. When a print job is sent tothe printer, it wakes up the printer in less than a minute. You can also wake the printer by pressing theOK key on the front panel.If you find that the printer is going into Power Saver mode too often and you do not want to wait whilethe printer wakes up, you can extend the length of time before the printer goes into Power Saver mode.Change the timeout on the front panel as follows:1. With Menus highlighted, press the OK key.2. Scroll through the menu to Printer Setup Menu using the Down Arrow key and press theOK key.3. Scroll through the menu to Set Power Saver Timeout using the Down Arrow key andpress the OK key.4. Select a Power Saver timeout value. Select a higher value if you want to extend the length of timebefore the printer goes into Power Saver mode.5. Press the OK key.To turn off the Power Saver feature, use the following procedure:1. With Menus highlighted, press the OK key.2. Scroll through the menu to the Printer Setup Menu and press the OK key.3. Scroll to the Reset Printer Menu using the Down Arrow key and press the OK key.4. Scroll through the menu to Power Saver using the Down Arrow key.5. Press the OK key to turn off.Protected mode for the front panel menusYou can put the printer into ìprotected modeî to prevent users from changing printer settings that mayimpact the prints of other users from the front panel. Instead, users can select printing features, such ascolor corrections, through the printer drivers only. In protected mode, users can access general menusthat can improve their print quality and direct them to user features, while locking the menus and itemsin menus that the system administrator uses to manage the printer.To enter or exit protected mode, use CentreWare IS software:1. From your printerís Internet Services home page, click Properties.2. On the left side of the Properties page in CentreWare IS, click Printer Defaults.3. If desired, change the setting for Front Panel Menus (under User Preferences on thePrinter Defaults page). Select Off to have all menus available. Select On to lock all menu items that change printer setup values.4. Click Save Changes on the bottom of the page.