Xerox WorkCentre 4150 Getting Started Manual

Also see for 4150 - WorkCentre B/W Laser: Service manual Service manual Brochure & specs Evaluator guide User guide

Xerox WorkCentre 4150 Getting Started Manual Manual pdf 8 page image

4 getting started guideSwitch On the WorkCentreOnce the WorkCentre has been assembled it must be configured. This is done using theProduct Enablement Key when the machine is switched on for the first time.The Product Enablement Key is deliveredin a plastic tube inside the box with themachine. The procedure to configure themachine is as follows:1 Locate the tube containing the ProductEnablement Key. Remove the plasticcard and carefully press out the key.2 Install the Product Enablement Key intothe Card Reader Slot on the left side ofthe machine.3 Connect the Power Cord to the machine and a suitable power supply outlet.4 Switch on the machine.5 The Language Default screen will be displayed. Select your chosen language and thenselect Save.6 The Installation Wizard screen will be displayed. Select Next.7 The Product Enablement Settings screen will be displayed. Follow the instructions on thescreen.NOTE: When the Green LED light stops blinking and remains on continuously (about 10seconds), the configuration is successful.Remove the Product Enablement Key and select Next on the displayCard ReaderslotOn/Off SwitchGreen LEDPower CordProduct EnablementKey