Xerox WorkCentre 7328 Quick Network Setup Manual

Also see for WorkCentre 7328: Quick use guide Quick use guide System administrator guide Copying guide Setup guide

Contents

prerequisites for manual setup of network using static ip address

Xerox WorkCentre 7328 Quick Network Setup Manual Manual pdf 1 page image

Xerox WorkCentre ® 7328/7335/7345Copyright © 2007, Xerox Corporation. All rights reserved.1Quick Network Setup GuideThis guide includes instructions for: Quick Network Setup (DHCP) on page 1 Quick Network Setup (Static IP) on page 3NoteFor more detailed instructions, see the System Administrator Guide.Quick Network Setup (DHCP)The System Administrator Guide contains detailed information about network setups. Thisdocument is intended for setting up the network using TCP/IP. If using Novel IPX, see theSystem Administrator Guide for setup procedures.Prerequisites for Quick Network Setup Using TCP/IP1. Confirm that an existing operational network utilizing TCP/IP is available.2. Confirm that the Ethernet cable is plugged into the multifunction device and into anoperational Ethernet port on the network.NoteThe Ethernet cable is an RJ45 type and is not supplied by Xerox.Configuring an IP Address via DHCPOn startup, the multifunction device defaults to DHCP to obtain its network configurations.A DHCP server delivers an IP address, as well as other configuration settings to the device. Ifyou use a DHCP server to allocate an IP address to the device, then proceed as follows:Procedure for Quick Network Setup Using TCP/IP1. Power on the device.2. Wait 3 to 5 minutes while the device negotiates an IP address.3. Print the Configuration Report:a. Press the Machine Status button on the device.b. Select the Machine Information tab.c. Touch Print Reports.d. Touch Copy Reports.e. Touch Configuration Report.f. Press the Start button, then touch Close.701P46042v1.0