Xerox WorkCentre 75xx Series Reference Manual

dc10cc0470Customer Support Page 7Fax SendMust use with the FAX_SEND Job Type command.Required CommandsPJL COMMENT Command DSC Comment Command@PJL COMMENT OID_ATT_JOB_TYPEOID_VAL_JOB_TYPE_FAX_SEND;@PJL COMMENTOID_ATT_FAX_DESTINATION_PHONE"xxxx";%%OID_ATT_JOB_TYPEOID_VAL_JOB_TYPE_FAX_SEND;%%OID_ATT_FAX_DESTINATION_PHONE "xxxx";Where xxxx is the phone number and any special access numbers. If a dialing prefix is added, it must beimmediately followed by a pause (comma) character. Each fax number can be up to 30 characters inlength.Optional Commands@PJL COMMENTOID_ATT_FAX_COVER_SHEET string;%%OID_ATT_FAX_COVER_SHEET string;Where string is:TRUEFALSE@PJL COMMENTOID_ATT_FAX_CONFIRMATION_SHEETstring;%%OID_ATT_FAX_CONFIRMATION_SHEET string;Where string is:TRUEFALSE@PJL COMMENTOID_ATT_FAX_RESOLUTION int;%%OID_ATT_FAX_RESOLUTION int;Where int is:0 – Fine Resolution1 – Standard Resolution2 – Super Fine Resolution@PJL COMMENT OID_ATT_FAX_TYPEOID_VAL_FAX_TYPE_string;%%OID_ATT_FAX_TYPEOID_VAL_FAX_TYPE_string;Where string is:G3_AUTO = Super G3 (33.6kbps)G3_14400 G3 = (14.4kbps)G3_FORCED_4800 = Forced 4800 bps)@PJL COMMENT OID_ATT_CREDIT_CARD "xxxx";Where xxxx is the credit card or charge code required to send the fax. Select this option and enter the creditcard number (up to 16 digits) if you want to charge the fax call to a credit card. The credit card number isconcealed on confirmation reports.Characters for phone numbers, prefix numbers, credit cards, and other numeric entries.* Begin DTMF# End DTMF: Switch to DTMF mode= Wait for dial tone.! Used to designate a mailbox signal., Used to initiate a pause period; default pause period is 3 seconds./ Used to delineate private data.$ Signifies to wait for a confirmation dial tone.<1> Use preceding a fax number to specify which fax line should be used on systems that support dual fax lines.<2> Use preceding a fax number to specify which fax line should be used on systems that support dual fax lines.