Xerox WorkCentre C226 Quick Connect Manual

Also see for WorkCentre C226: User guide Quick start guide System administration guide

Contents

Xerox WorkCentre C226 Quick Connect Manual Manual pdf 1 page image

WorkCentre C226Quick Connect GuidePurpose:Refer to this guide to modify the printer network settings at the printer userinterface screens if required. For complete instructions refer to the Customerdocumentation for additional information.Note:A Network Administrator is required to ensure that the printer is configuredproperly. To properly configure the printer, the Network Administrator mustsupply a valid IP Address, a Subnet Mask, and a Gateway Address if applicable.DHCP is enabled by default. For more information in regards to Novell printingand configuration, please refer to the Customer documentation.Procedure:The WorkCentre C226 has been designed to connect to a TCP/IP network withminimal changes. Connect the printer to the network and review the NetworkSettings List. Continue with Steps 2-6 and make changes to the printer port /network as required for your network infrastructure.Step 1: Default Printer SettingsDefault Port SettingsParallel Port – EnabledNetware – EnabledPort 9100 – EnabledFTP – EnabledInternet Service – EnabledDefault Network SettingsIP Address DHCP (ON)Printer Name: XC010228Workgroup: WorkgroupStep 2: IP SetupFollow this procedure if you want to make any changes to the port settings. If nochanges are required then please move on to Step 3.1. Press Machine Administration button on the Local User Interface Operation Panel.2. Press System Administrator Tools button. Enter Password (Default: 00000).3. Press Printer Selections.4. Press Network Settings.5. Press IP Address Settings.6. DHCP is default – uncheck DHCP and enter IP information if applicable.7. Press OK.8. Press Yes to restart after making changes.9. Reboot the printer using on/off switch on the left side of machine.10. If no further changes are required, continue to Step 4 in this guide.