Xerox WorkCentre Pro 75 Operator's Manual

Also see for Docuprint 75: Getting started Software guide Planning guide Supplementary guide Software guide

Contents

Xerox WorkCentre Pro 75 Operator's Manual Manual pdf 61 page image

Operator Guide Paper and other stockDocuTech/DocuPrint 75/90 and DocuPrint 75 MX 5-3Tray 6 The High Capacity Tray has a capability of only 8.5 x 11 inch(216 to 279 mm) or A4 long-edge feed (LEF), between 16-32 lb(75-120 gsm).Trays 1-4 Have a capability of 8 to 17 inches (203 to 432 mm); 5.25 to 11inches (133 to 279 mm). Call the Welcome Center if you want topermanently set any of the Trays 1-4 to process 12 x 18 inch(305 x 457 mm) stock.General stapling guidelinesTo ensure that stapling of thin sets is satisfactory, finishers thatare produced after 1998 will cycle down after 30 sets of up to 15sheets or less. You must empty the stacker in order to resumeprinting.If these parameters are not satisfactory for your printing, pleasecontact Xerox.Dimensions that can be stapled: The minimum size forstapling is 6.7 by 8 inches (170 x 203 mm). The fed edge mustbe between 8 to 12 inches (203 x 305 mm) to be stapled.Figure 5-3. Size requirements for staplingWeights that can be stapled: The Finisher can staple amaximum of 50 sheets of 20 lb paper. The maximum staplecapability for other stock weights is shown in Table 5-1.This edgemust bebetween 8 to12 inches (203to 305 mm) tobe stapled.FeedDirectionTable 5-1. Staple capability for various paper weightsWeight Maximum Number of Stapled Sheets20 lb 75 gsm 5024 lb or 90 gsm 44