Xerox XES 8855 User Manual

Also see for Synergix 8855: Operator's manual System introduction Supplementary guide Software guide Supplementary guide

Xerox XES 8855 User Manual Manual pdf 5 page image

Safety NotesYour XES Synergix 8825/8830/8855 Digital Solution has been designed andtested to meet strict safety requirements. These include safety agencyexamination and approval plus compliance with established environmentalstandards.Please read the following instructions carefully before operating the XESSynergix 8825/8830/8855 Digital Solution and refer to them as needed toensure continued safe operation.Follow all warnings and instructions marked on or supplied with the product.Unplug the units from the wall outlet before cleaning the exterior. Always usematerials specifically designated for the XES Synergix 8825/8830/8855 DigitalSolution. Use of other materials may result in poor performance and couldcreate a hazardous situation.Do not use aerosol cleaners. Follow the instructions in this operator manualfor the proper cleaning methods.Never use supplies or cleaning materials for purposes other than what theywere intended. Keep all supplies and materials out of the reach of children.Do not use the units near water, wet locations, or outdoors.The components of this product are equipped with a three-wire, grounding-type plug (i.e., a plug having a grounding pin). This plug will only fit into agrounding-type power outlet. This is a safety feature. To avoid the risk ofelectric shock, contact your electrician to replace the receptacle if you areunable to insert the plug into the outlet.Never use a ground adapter plug to connect the system to a power source thatlacks a ground connection terminal.This system should be operated from the type of power source indicated onthe marking label. If you are not sure of the type of power available, consultyour local power company.The power supply cord is the disconnect device for this equipment. Make surethat the installation is near the socket outlet and is easily accessible.Do not allow anything to rest on the power cord. Do not locate the units wheresomeone will step on the cord.