Xilinx KC705 Getting Started

Also see for KC705: User guide User guide User guide User guide

Contents

Xilinx KC705 Getting Started Manual pdf 8 page image

8 www.xilinx.com KC705 Getting Started GuideUG913 (v1.0.1) May 31, 2012Chapter 1: Getting Started with the Kintex-7 FPGA KC705 Embedded KitVideo Demonstration Hardware Setup Instructions1. This demonstration requires default switch and jumper settings on the KC705 board.For more information on the default switch settings, refer to the “Hardware Test BoardSetup Requirements” section of UG883, Kintex-7 FPGA KC705 Evaluation Kit GettingStarted Guide.2. Connect the KC705 board, HDMI cables, display monitor, Ethernet cable, and USBcables as shown in Figure 1-2.3. Set the IP address of the host PC to 192.168.1.100. Return the IP address of the PC backto its original setting after running the demonstration.Note: The demonstration uses a hard-coded MAC address and a fixed IP address of 192.168.1.10and does not connect to the regular LAN network using DHCP. Do not connect more than one boardto the same network segment.Running the Video DemonstrationTo run the video demonstration, copy and unzip the demonstration package files eitherfrom the USB flash drive or from the Web to the host machine and follow these steps:1. If the KC705 board is not already powered on, plug in the power adapter to local ACpower. Plug the 12V power cable into the board connector on J49. Turn on the powerby switching the SW15 to the ON position.2. Open and configure a serial communications terminal utility program with thesesettings:• Baud Rate: 9600• Data: 8 bitX-Ref Target - Figure 1-2Figure 1-2: Kintex-7 FPGA Video Demonstration Hardware SetupPOWERSUPPLYHDMI_OUT1080PUG913_c1_02_051612EthernetUARTKC705 EvaluationBoardJTAG