Xomax XM-2R422 User Manual
Also see for XM-2R422: User manualInstallation manual
                | |
INSTALLATIONInstallation ProceduresFirst complete the electrical connections and then check for correctness.Installation OpeningThis unit can be installed in any dashboard Having an opening as shown the right figure.To Install the Car RadioBe sure you test all connections first, and then follow these steps to install this unit.1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery’snegative (-) terminal.2. Disconnect the wire harness and the antenna.3. Lift the left or right top corner of the plastic outer trim ring then pull it out to remove it.4. Insert the two bracket keys into the left and right side of the chassis, as shown the belowfigure to separate the chassis from the housing.5. Insert mounting sleeve into the dashboard and bend the mounting tabs out with a screw-driver. Make sure that the lock lever is flush with the mounting sleeve and is not projectingbeyond.6. Insert car radio into the mounting sleeve.7. Use a metal strap to secure the rear part of the chassis using the hardware indicated.8. Make wiring connections, as illustrated in the “Wiring Diagram.”9. Install the plastic outer trim ring.2Bracket keyPlastic outer trim ringBracket key182 mm103 mm |
Related manuals for Xomax XM-2R422
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine