Xray NT1 Instruction Manual
                                                    | |
45Use appropriate servo arm:K - (23T)H - (24T)F - (25T)901303SB M3x3902310SH M3x10902306SH M3x6Screw from servo(NOT INCLUDED)Insert rod through hole in brakearm. Bend rod to proper shape.Approx.15mmDo not overtightenscrews; pivots mustrotate freelyThread6mm THREAD8mm THREAD9. CARB LINKAGE & BODYMOUNTSHUDY ALU SERVO HORNS#293494 23T KO Propo, Airtronics, JR, Sanwa#293495 24T Hitec#293496 25T FutabaDETAIL#332630 ADJ. TURNBUCKLE L/R 25 MM - HUDY SPRING STEEL™ (2)#302663 COMPOSITE BALL JOINT 4.9MM - OPEN (8)#362650 BALL END 4.9MM WITH THREAD 6MM (2)#362651 BALL END 4.9MM WITH THREAD 8MM (2)OPTIONAL REAR STIFFENER LINKIMPORTANT 6.3mmIt is important to have the exact length of the linkage.Too long or too short link will cause the chassis tobend and unwanted tweak problems. To check thatthe legth is correct, composite balls must move freely.#334061-OALU BRAKE POST ARM - SWISS 7075 T6 - ORANGENOTEORIENTATIONIMPORTANT:The composite holders and servo horn orientationdepend on the servo type and servo position whichcan be mounted either from top of the radio plateor from the bottom. |
Related manuals for Xray NT 1.2
manualsdatabase
Your AI-powered manual search engine