Xterra TR3.0 Owner's Manual

Contents

Xterra TR3.0 Owner's Manual Manual pdf 23 page image

TR3.0 Treadmill21Belt/Deck Lubrication ProcedureFirst, you want to clean between the belt and deck to remove any debris that may be trapped.Use a clean, non-fraying rag, t-shirt, or light towel. Halfway between the end of the treadmilland motor cover, shove the garment under the belt until you can grasp it on both sides of thebelt. Drag the garment the length of the entire belt 1-2 times. Remove the garment.Do not lubricate with anything other than XTERRA Fitness approved lubricant. Your treadmillcomes with one tube of “Lube” and extra tubes can be ordered directly fromwww.xterrafitness.com.Keeping the deck lubricated at the recommended intervals ensures the longest life possiblefor your treadmill. If the lubricant dries out, the friction between the belt and deck rises andplaces undue stress on the drive motor, drive belt and electronic motor control board, whichcould result in failure of these components. Failure to lubricate the deck at regular intervalsmay void the warranty.The belt & deck come pre-lubricated and subsequent lubrication should be performed every90 hours of use or if you notice that the deck is dry. It is recommended that you reach be-tween the belt and deck to verify there is lubrication present, every other month. If you checkand there isn’t any lubrication present, follow the procedure below even though the “Lube”indicator isn’t lit on the console. Otherwise, lubricate when the console’s lubrication reminderlights after 90 hours of use. Use the following procedure to apply the silicone lubricant:1. Turn the power switch off and unplug the power cord from the wall outlet2. Measure 18” from the edge of the motor cover; kneel down and reach under the beltapproximately 4- 6” from one edge. Squirt a line of lubricant about 1/8” wide x 15” longin an “S” pattern perpendicular to the motor cover.3. Repeat the process on the opposite side.4. Plug the electrical cord back into the outlet and turn the power switch on.5. Walk on the belt at a moderate speed for five minutes to evenly distribute the siliconelube.6. Note: If the “Lube” message appears on the console, perform the following procedure toreset the message:1. To enter the Engineering Mode Menu press and hold down the Start, Stop andEnter keys, then at the same time insert the safety key. Keep holding the keys downuntil the Display displays Engineering Mode Menu. Press the Enter key to access2. Press the Speed 5 key (or Speed 6 key to go backwards) until “Functions”appears; press Enter3. Press the Speed 5 key until “Reset Lube” message appears; press Enter4. Press Stop to exit Engineering mode and resume use of your treadmill