YASKAWA DX100 Instructions Manual

Also see for MOTOMAN DX100: Instruction manual Instructions Instructions Instruction manual Instruction manual

Contents

YASKAWA DX100 Instructions Manual Manual pdf 13 page image

3-1156527-1CDHW1480826I/O Expansion EuropeanStandard (PNP)3 Setting the Functions3.1 Function Setting Switches3 Setting the Functions3.1 Function Setting SwitchesThe section explains the switches that set the functions of the XOI02Bboard. Make the proper settings following the instructions. For details ofthe settings, refer to page 3-2.S1: Sets the stations for the XOI02B board on the DX100.The setting range for a station is 1 (ST#01) to D (ST#13).Do not set the station to 0 (ST#00), E (ST#14), or F (ST#15).JP1: Sets the communication speed.This switch sets the communication speed to 4 Mbps or 10 Mbps.Be sure to set this switch to 4 Mbps.Do not set it to 10 Mbps.If the number of I/O points on the XOI02B board does not appearon the Programming Pendant, check if the communication cableor power cable is connected correctly, referring to the I/O modulesetting in Chapter 5 "I/O Signal Allocation" on page 5-1. When thecables are correctly connected, the JP1 may be set to 10 Mbps.Change the setting to 4 Mbps.JP2: Sets the communication mode.This switch sets the communication mode to 16 bytes, 17 bytes, or32 bytes.Be sure to set this switch to 17 bytes.Do not set it to 16 bytes and 32 bytes.If the number of I/O points on the XOI02B board does not appearon the Programming Pendant, check if the communication cableor power cable is connected correctly, referring to the I/O modulesetting in Chapter 5 "I/O Signal Allocation" on page 5-1. When thecables are correctly connected, the JP2 may be set to 16 bytes or32 bytes.Change the setting to 17 bytes.13/36