YUKEN KOGYO ASE Series Instruction Manual
Also see for ASE Series: Manual
                                                                                  | |
EM-0146-8- -92.5 SpecificationsTable 2.5a SpecificationsModel ASE3-*AA-G80*- ASE5-*BZ-G130*- ASE10-4CE-G200*-Max. Flow L/min 80.8 132.7 205.4Min. Controlled Flow 2 %Hysteresis 1 % or lessRepeatability 1 % or lessFlow ControlInput Signal Voltage *1 0 to 6.25 V 0 to 5.75V 0 to 5.00VPres. Adj. Range MPa 0.1 to 17.5Hysteresis 1 % or less *2Repeatability 1 % or less *2Pres. ControlInput Signal Voltage *1 0 to 5.0 VAtmosphere Indoors (no direct sunlight)No corrosive gas, flammable gas, oil mist, or dust.Altitude 1000 m or less above sea levelAmbient Temp. 0 to 40 °C (no freezing)Storage *3Ambient Humidity 80 %RH or less (no condensation)*1 Default value (allowable maximum input signal voltage: up to 10 V).*2 Pressure control accuracy depends on system tuning; this value is for reference.*3 The storage temperature is different from the ambient temperature during operation.Table 2.5b ASE (Pump) SpecificationsTable 2.5c AC Servo Motor SpecificationsModel ASE*-**-***-Operating Pres. 0.1 to 17.5 MPaRotational Direction Clockwise when viewed from the servo motorHydraulic Fluid Petroleum based fluid equivalent to ISO VG32 or 46Viscosity 20 to 400 mm2/sFluid Temp. 0 to 60 °CModel ASE*-**-***-Insulation Class Class FCooling System Totally-enclosed forced-coolingProtection IP44 (except for the shaft through portion)Ambient Temp. 0 to 40 °C (no freezing)Ambient Humidity 80 %RH or less (no condensation)EnvironmentalConditionVibration 24.5 m/s 2 or less (When the motor stops, reduce the allowable value to less than one-half.)Fan PowerVoltage/Frequency Single-phase, AC 180 to 220 V, 50/60 Hz |
Related manuals for YUKEN KOGYO ASE Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine