Yaesu FT-1000MP Installation Instructions Manual

Contents

parts list

3Rear Panel Ground+5VBoardstandoffsgo herePads already filled with solder.1. Strip 3/16" and tin.2. Leave insulation on.Hold with pliers.3. Touch with solderingiron and push 1/8" of wirethrough the opening in thepad.INSTRUCTIONS FOR THE FT-1000MP MARK V AND MARK V FIELDThe male connector used in the FT-1000MP to power the Inrad IF mod has beenleft off of the Mark V audio board. In order to power the Inrad mod, two # 22 wires, eachabout 1 " long, must be inserted into the pad holes as shown.-These wires should be formed to stand straight and vertical after installation.-The wire insullation should be removed after soldering.-Next the plastic board standoffs should be inserted into the holes provided.-Then the Inrad mod can be lowered in place so the #22 wires go into the proper holes in themod connector. No soldering is required, as the wires are acting as connector pins.-After the mod is in place the excess #22 wire should be trimmed off.Note: Use care that the wires are not pushed too far through the pad holes, as theymay contact the chassis and short the +5 volts.PARTS LISTAssembled IF Mod (Inrad 105)Coax cable 8”Board mounts with nuts0.047 uF Mylar capacitor2” #22 insulated solid wireInternational Radio © 2005. Modifications done at your own risk; seek help if you are not qualified. International RadioCorp. assumes no responsibility for any damages or injuries resulting from improper installation of this modification kit.

/ 4

Related manuals for Yaesu FT-1000MP MV