Yaesu FT-950 - MENU MODE LIST Manual

Also see for FT-950: Brochure & specs Reference Update Update Update

Contents

Page 114 FT-950 OPERATING M ANUALMODE-SSB GROUP064 J3E TX BPFFunction: Selects the audio passband of the DSP modula-tor on the SSB mode.Available Values: 1-30/1-29/2-28/3-27/4-26Default Setting: 3-27: 300 ~ 2700 (Hz)1-30: 100 ~ 3000 (Hz)1-29: 100 ~ 2900 (Hz)2-28: 200 ~ 2800 (Hz)3-27: 300 ~ 2700 (Hz)4-26: 400 ~ 2600 (Hz)NOTE:The apparent power output, when using the widest band-widths, may seem lower. This is normal, and it occurs be-cause the available transmitter power is distributed over awider bandwidth. The greatest compression of power out-put, conversely, occurs when using the “4-26” setting (400~ 2600 Hz), and this setting is highly recommended forcontest or DX pile-up work.065 J3E LSB CARFunction: Adjusts the receiver carrier point for the LSBmode.Available Values: –200 Hz ~ +200 Hz (10 Hz steps)Default Setting: 0 Hz066 J3E USB CARFunction: Adjusts the receiver carrier point for the USBmode.Available Values: –200 Hz ~ +200 Hz (10 Hz steps)Default Setting: 0 HzRX GENERAL G ROUP067 RGEN NB 1 LVLFunction: Adjusts the noise blanking level of the IF NoiseBlanker for short duration pulse noise.Available Values: 0 ~ 255Default Setting: 128068 RGEN NB 2 LVLFunction: Adjusts the noise blanking level of the IF NoiseBlanker for longer duration pulse noise.Available Values: 0 ~ 255Default Setting: 128069 RGEN CNTR LVFunction: Adjusts the parametric equalizer gain of theContour filter.Available Values: –40 ~ +20 dBDefault Setting: –15 dB070 RGEN CNTR WIFunction: Adjusts the Q-factor of the Contour filter.Available Values: 1 ~ 11Default Setting: 10071 RGEN DNFFunction: Enables/disables the Digital Notch Filter.Available Values: OFF/OnDefault Setting: OFF072 RGEN DNRFunction: Set the Digital Noise Reduction response.Available Values: OFF/1 ~ 15Default Setting: OFFMENU M ODEIFBANDWIDTH“+” Gain“Q”“--” GainCONTOUR “G AIN ” AND “Q”