Yaesu FTM-10R - QUICK CODE SHEET Manual
Also see for FTM-10R: Brochure & specsTechnical supplementOperating manualEasy Programming Guide
  | |
Contents | 
Memory Set ModePress and hold the key for one second to enter the Memory Channel Set Mode.Clock/Timer Set ModePress and hold the [VOL/SEL] key for one second to enter to the Clock/Timer Set Mode while the clock/timerfunction is activated.Smart Menu KeyTop panel / keys, and the key select and enable operation of the following features.DisplayT 1 TIME ADJT 2 CLOCK BPT 3 T FORMATT 4 12H/24HT 5 TMR BEEPT 6 APOFunctionSet up the Clock.Set an alarm beep which will sound every “00” minutes.Change the Clock Format.Change the Time System.Stop Watch Timer allows programming a timed interval when a beep will sound andthe white LED will flash.Selects the Automatic Power Off time (time before power goes off).Page538483848485Page2526272727272728282929303130323232FunctionPress the key to activate the AF Dual function.Press the key to activate the ARTS feature.Press the key to enable adjustment of the display illumination level by the DIAL knob.Press the PTT switch to activate the sound of a Gong Bell.Press the PTT switch to activate the sound of a UFO in flight.Press the PTT switch to activate the sound of a klaxon.Press the PTT switch to activate the sound of a siren.Press the key to activate the Intercom mode.Press the key to disable noise and tone squelch.Press the PTT switch to route your amplified voice through the PA speaker.Press the key to activate the Reverse feature.Press the key to activate the scanner.Press the key to activate the Smart Search.Press the key to enable adjustment of the noise squelch threshold level by the DIAL knob.Press the key to activate the 1750 Hz Tone Burst.Press the key to change the transmit power level.Press the key to change the receiver audio level of the intercom receiver.DisplayAF DUALARTSDIMMERHORN 1HORN 2HORN 3HORN 4INTERCOMMONIPAREVERSESCANSQL LEVLSSCHTCALLTX POWERVOL.ITCOMWhen one of the above features does not appear in the list, it is because that feature is not assigned to the top panel/ keys. Please insure the Smart Menu “F14 FKEY MOD” is set to “FNC” or “FNC+MSG”.DisplayM 1 GROUPM 2 MEM CHM 3 MEM SORTM 4 MEM TAGM 5 SCN TYPEM 6 SKIPONLYM 7 SQL LEVLM 8 SQL TSQFM 9 SQL DCSM10 SQL TYPEM11 TX SHIFTM12 TX POWERM13 DELETEPage36373738393940404141424343FunctionAssigns/Eliminates the memory channel to/from the Memory Group Memory bank.Changes the memory channel number to the desired vacant memory channel number.Sorts and renumbers the Memory Channels by frequency, from low to high.Appends an Alphanumeric “Tag” (label) to a memory channel.Sets the Scan Type (Skip Memory or Preferential Memory).Set the Preferential Scan List.Sets the Squelch Threshold Level.Change the CTCSS Tone Frequency.Change the DCS Code.Change the Squelch Type (CTCSS or DCS).Stores an independent (in band) transmit frequency (Odd Split).Change the Transmitter Power Level.Deletes memorized data (except CLUB memory channel). |
Related manuals for Yaesu FTM-10R
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine