Operation56TIP:The start-in-gear protection device preventsthe engine from starting except when in neu-tral.2. Attach the engine shut-off cord to a se-cure place on your clothing, or your armor leg. Then install the clip on the otherend of the cord into the engine shut-offswitch.3. Place the throttle grip in the “ ”(start) position. After the engine starts,return the throttle to the fully closed po-sition.4. Turn the main switch to “ ” (start),and hold it for a maximum of 5 seconds.5. Immediately after the engine starts, re-lease the main switch and allow it to re-turn to “ ” (on). NOTICE: Never turnthe main switch to “ ” (start)while the engine is running. Do notkeep the starter motor turning formore than 5 seconds. If the startermotor is turned continuously formore than 5 seconds, the battery willbe quickly discharged, thus making itimpossible to start the engine. Thestarter can also be damaged. If theengine will not start after 5 secondsof cranking, return the main switch to“ ” (on), wait 10 seconds, thencrank the engine again. [ECM00192]TIP:● When the engine is cold, it needs to bewarmed up. For further information, seepage 58.● If the engine is warm and fails to start,open the throttle slightly and try to start theengine again. If the engine still fails tostart, see page 92.EMU27664Electric start and remote control modelsWARNINGEWM01840● Failure to attached engine shut-off cordcould result in a runaway boat if opera-tor is ejected. Attach the engine shut-
