Components24EMU30900Variable trolling RPM switchesThe trolling speed can be adjusted when theoutboard motor is trolling. Press the “ ”switch to increase the trolling speed andpress the “ ” switch to decrease the trollingspeed.TIP:● The trolling speed changes approximately50 r/min each time a switch is pressed.● If the trolling speed has been adjusted, theengine returns to the normal trolling speedwhen the engine is stopped and restartedor when the engine speed exceeds ap-proximately 3000 r/min.● For instructions on using the variable troll-ing RPM switches, see page 53.EMU26244Trim tab with anodeWARNINGEWM00840An improperly adjusted trim tab couldcause difficult steering. Always test runafter the trim tab has been installed or re-placed to be sure steering is correct. Besure you have tightened the bolt after ad-justing the trim tab.The trim tab should be adjusted so that thesteering control can be turned to either theright or left by applying the same amount offorce.If the boat tends to veer to the left (port side),turn the trim tab rear end to the port side “A”in the figure. If the boat tends to veer to theright (starboard side), turn the trim tab end tothe starboard side “B” in the figure.NOTICEECM00840The trim tab also serves as an anode toprotect the engine from electrochemicalcorrosion. Never paint the trim tab as itwill become ineffective as an anode.1. Power trim and tilt switch1. Variable trolling RPM switchUPDNZMU0363411. Trim tab2. Bolt3. Cap123ZMU02525AB
