Yamaha HS10W Service Manual

Also see for HS10W: Owner's manual Owner's manual

Contents

8HS10WINPUTKnob (LOW CUT, HIGH CUT)(Photo 7)(Photo 4) (Photo 5)(Photo 6)[E]Q610 Q611Q610 Q611[E]• AMP assemblyAMPQ607Q607• AMP assemblyAMPTRANSPower transformerSolder Solder2-4. TRANS Circuit Board(Time required: About 3 minutes)2-4-1 Remove the four (4) screws marked [38]. The TRANSassembly can then be removed. (Photo 3)2-4-2 Remove the solder (8 points) on the pattern side forattaching the power transformer. The power transformerand TRANS circuit board can then be removed. (Photo 6)2-5. INPUT Circuit Board(Time required: About 5 minutes)2-5-1 Pull out the knob (LEVEL). (Photo 3)2-5-2 Remove the two (2) hexagonal nuts marked [A], and thehexagonal nut and the washer marked [B]. (Photo 3)2-5-3 Remove the seven (7) screws marked [95], and four (4)screws marked [98]. The INPUT circuit board can thenbe removed. (Photo 3)2-5-4 Remove the two (2) knobs (LOW CUT, HIGH CUT) fromthe INPUT circuit board. (Photo 7)* The knobs are not part of the INPUT circuitboard. When replacing the INPUT circuit board,remove the knobs and install them to the newINPUT circuit board.www . xiaoyu163. comQQ 376315150 992894298TEL 13942296513 992894298051513673QQTEL 13942296513 QQ 376315150 892498299TEL 13942296513 QQ 376315150 892498299http://www.xiaoyu163.comhttp://www.xiaoyu163.com