MSR100/SMS10084. Speaker HF (Tweeter)(Time required: About 3 minutes)4-1 Remove the front grille assembly. (See procedure 1.)4-2 Divide the front cabinet unit and the rear cabinetunit. (See procedure 3.)4-3 Remove the wire HF (yellow/blue) installed to thespeaker HF (Tweeter). (Photo.2)4-4 Remove the two (2) screws marked [46]. The speakerHF (Tweeter) can then be removed from the frontcabinet unit. (Fig.3)5. Network Assembly and NETWORK CircuitBoard (Time required: About 4 minutes)5-1 Remove the front grille assembly. (See procedure 1.)5-2 Divide the front cabinet unit and the rear cabinetunit. (See procedure 3.)5-3 Remove the four (4) screws marked [10e]. Thenetwork assembly can then be removed from therear cabinet unit. (Fig.4)5-4 Remove the four (4) screws marked [N40]. Thenetwork holders C and D can then be removed fromthe NETWORK circuit board. (Fig.4)Remove the P1, P2 connector assembly solderedto the NETWORK circuit board.[46]: Bind Head Tapping Screw-B 4.0X20 BL (AAX42200)Fig.3Fig.4[10e]: Bind Head Tapping Screw-B 3.0X10 BL (AAX10840)[N40]: Cup Screw-B PW3.0X8 Y (AAX43390)[46]Front Cabinet UnitSpeaker HF (Tweeter)Network assemblyNetwork holder DNetwork holder C[N40][10e]Rear Cabinet UnitNETWORKSpeaker HF (Tweeter)Wire HF (Yellow)Wire HF (Blue)Photo.2www . xiaoyu163. comQQ 376315150 992894298TEL 13942296513 992894298051513673QQTEL 13942296513 QQ 376315150 892498299TEL 13942296513 QQ 376315150 892498299http://www.xiaoyu163.comhttp://www.xiaoyu163.com