Yamaha NS-AP2800 Owner's Manual

Contents

4SETTING UP THE SPEAKERSAttaching the non-skid pads to the speakersPlace the speakers on a sturdy, vibration-free surface, such as a well-built stand. Attach the included non-skidpads to the bottom of the speakers to prevent the speakers from slipping.Wall mounting the front and/or surround speakersWhen mounting the speakers on a wall, attach one of the non-skid pads provided near each of the corners onthe rear surface of the speaker to prevent the speaker cable from being caught between the wall and thespeaker.You can also use the screw holes on the back of the speaker forinstalling the speakers on commercially available speaker brackets.2-3/8 (60 mm)A screw with a diameter ofcan be used.(Hole depth:9/32 )Wall / wall supportTapping screw(Available at the hardware store)When using speaker brackets to mount the speakers on a wall or ceiling, it is strongly recommended thatsafety wire, which may be included with the bracket, be used between the speaker and the bracket to preventthe speaker from falling.Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mountingbracket on the protruding screws.Make sure that the screws are securely caught by the narrow sections of the key hole opening.WARNINGEach speaker weighs 2.05 lbs (0.93 kg). Do not mount the speakers on thin plywood or a wall with softsurface material, since the screws may pull away from the surface and fall. This will damage the speakersand can cause personal injury.Do not mount tne speakers on a wall with nails, adhesives, or any other unstable hardware. Long-termuse and vibrations may cause them to fall.To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall orfloor molding.Secure installation is the purchaser s responsibility.1/4