Yamaha NS-AW992WH User Manual
Also see for NS-AW992: User guide
 |
1 2365a× 410 mm(3/8˝)–+NS-AW992 (R) NS-AW992 (L)–+ –+158208 233169.210540.9127ø206×115.5×10117ø5.55469.528375617ø54ø6388× 2× 2NS-AW992OUTDOOR SPEAKERENCEINTE D’EXTERIEURUCG©2009 Yamaha Corporation All right reserved.Printed in Indonesia WT55050Speaker output terminalsBornes de sortie enceinteLautsprecherausgangs-klemmenAmplifier or receiverAmplificateur ou récepteurVerstärker oder Receiver [mm]CONSUMER PRECAUTIONSRead these precautions carefully before setting up your NS-AW992speakers.• When mounting these speakers, be sure to work with two or morepersons for safety.• When installing these speakers outdoors, try to minimize theirexposure to rain and snow by mounting the speaker in corners orunder eaves.• Since these speakers are to be wall / ceiling mounted, it is essentialthat they are firmly secured. Be sure to consult a reliable sourceabout the best type of fastener for your particular wall / ceiling’sconstruction.• Do not attach them to thin plywood or soft wall / ceiling surfacematerials as the screws may tear free, causing the speakers to falland be damaged, or result in personal injury.• Do not fasten the speakers to wall / ceiling with nails, adhesives, orother unsafe hardware. Long-term use and vibrations may causethem to pull free.• Do not place the speakers where they are liable to be knocked overor struck by falling objects. Stable placement will also ensure bettersound performance.• When changing the angle of the speakers, be sure to adjust theangle after loosening the knob on the both sides. The speakers maybe damaged by excessive power.• Lower the power amplifier / receiver volume control before changinginput sources. Always turn the amplifier / receiver unit off wheninstalling or removing input cables.• Anytime you note distortion, reduce the volume control on yourpower amplifier / receiver to a lower setting. Never allow your poweramplifier to be driven into “clipping”.• Do not attempt to modify or fix the speakers. Contact qualifiedYamaha service personnel when any service is needed. The cabinetshould never be opened for any reasons.• Do not attempt to clean the speakers with chemical solvents as thismight damage the finish. To clean wipe with a dry, soft cloth.• Secure placement or installation is the owner’s responsibility.Yamaha shall not be liable for any accident caused by improperplacement or installation of speakers.After unpacking, please inspect contents to confirm all the followingitems are contained.Speaker × 2Bracket × 2Knob × 4To wall / ceiling mount the speakers, use the included bracket.Using the bracket as a template mark the locations (four points) ofthe key hole slots on the mounting area.Using appropriate hardware (not included) securely fasten thebracket to the wall / ceiling.Position the speaker in the bracket and secure the speaker byusing the two knobs included.Rotate the YAMAHA emblem according to the position of thespeaker.When using the brackets to mount the speakers on a wall / ceiling,please use safety wire (not included) between the speaker and thebracket to prevent the speaker from falling. Please use safety wirewhich withstand load is 3.7 kg (8.2 lbs.) or more. Fix the safety wire withM5 screw (inch screw: No. 10-32) by using the screw hole [diameter: 5mm (1/4″), depth: 15 mm (5/8″)] at the rear of the speakers. For safety,please confirm that installed screw is in the screw hole more than 10mm (3/8″).Before making connections, make sure that the amplifier / receiver isswitched off.CONNECTIONS• Connect the input terminals at the rear of the speakers to thespeaker output terminals of the amplifier / receiver with the speakercables (not included).• Connect each speaker making sure not to reverse the polarity“+” (red), “–” (black). If the speaker is connected with reversedpolarity, the sound will be unnatural and lack bass.HOW TO CONNECTRemove approximately 10 mm (3/8″) of insulation from the end ofeach speaker cable and twist the exposed wires of the cabletogether to prevent short circuits.Unscrew the terminal knob.Insert one bare wire into the hole in the side of each terminal.Tighten the terminal knob to secure the wire.SPECIFICATIONS (For single speaker)* Specifications subject to change without notice due to productimprovements.English1 UNPACKING2 MOUNTING THE SPEAKERSIf speaker cable (not included) is being fed from a hole in the wall /ceiling behind the bracket, pull this speaker cable through the hole inthe bracket before mounting the bracket [figure - ].2 a3 CONNECTING YOUR AMPLIFIER / RECEIVERNote: Do not let the bare speaker wires touch each other as this coulddamage the speaker or amplifier / receiver, or both.Type 2-Way Acoustic SuspensionDriver Tweeter 2.5 cm (1″) soft dome typeWoofer 20 cm (8″) cone typeFrequency response 50 Hz to 20 kHz (–10 dB)Impedance 6 ohmsNominal input 60 WMaximum input 180 WSensitivity 90 dB / 2.83 V, 1 mCrossover frequency 6 kHzDimension (W × H × D)(excluding bracket andknobs)233 × 388 × 208 mm(9-1/8″ × 15-1/4″ × 8-1/4″)Weight (including bracketand knobs)4.15 kg (9.1 lbs.)IP rating IPX3Materials of the mainpartsEnclosure: HIPSPunching grill: Aluminum (powder coating)Bracket: Steel [t = 1.6 mm (1/16″)] (powdercoating)Movable angle 10 degree pitchWarranty policy for European Economic Area (EEA) andSwitzerland, Australia customerIn the unlikely event that your Yamaha product needs guarantee service,please contact the dealer from whom it was purchased. If you experienceany difficulty, please contact Yamaha representative office in your country.You can find full details on our websiteEEA and Switzerland: (http://www.yamaha-hifi.com/ or http://www.yamahauk.com/ for U.K. resident).Australia: (http://www.yamahamusic.com.au/)Warranty policy for U.S. and Canada customerYour Yamaha product is covered by a limited warranty for two years fromthe date of purchase. In the unlikely event of failure due to defectivematerials or workmanship, Yamaha will repair or replace them at nocharge.For full details, please see the included warranty card or visit our website.U.S.: (http://www.yamaha.com/yec/), Canada: (http://www.yamaha.ca/)Information for Users on Collection and Disposal of Old EquipmentThis symbol specified in the Directives 2002/96/EC indicatesthat used electrical and electronic products should not bemixed with general household waste.For proper treatment to avoid harmful effect on human healthand environment, please contact your local municipality, yourwaste disposal service or the point of sale where you purchased theitems. |
Related manuals for Yamaha NS-AW992
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine