E-10USING THE SUBWOOFER (SW-P201)1 POWER switchSet this switch to the ON position to turn on the powerof the subwoofer. When the power of the subwoofer ison, the power indicator below the POWER switch lightsup GREEN. Set this switch to the OFF position to turnoff the power of the subwoofer.2 Power indicatorLights up GREEN when the POWER switch is set tothe ON position and goes off when set to the OFFposition.* Standby modeIf the POWER switch is set to the ON position andthe AUTO STANDBY switch is set to the HIGH orLOW position, this indicator lights up RED when nosignal is inputted to the subwoofer.3 AUTO STANDBY (HIGH/LOW/OFF) switchBy setting this switch to the HIGH or LOW position, thesubwoofer’s automatic power-switching functionoperates as described on the next page. If you do notneed this function, set to the OFF position.* Make sure to change the setting of this switch onlywhen the POWER switch (1) is in the OFFposition.Standby modeThe subwoofer is still using a small amount of powerin this mode.4 INPUT2 terminalsUsed to input line level signals from the amplifier.5 INPUT1 (FROM AMPLIFIER) terminalsUsed to connect the subwoofer with the speakerterminals of the amplifier.6 OUTPUT (TO SPEAKERS) terminalsCan be used for connecting to the main speakers.Signals from the INPUT1 terminals (5) are sent tothese terminals.7 VOLUME controlAdjusts the volume level.8 VOLTAGE SELECTOR switch (General model only)If the preset setting of the switch is incorrect, set theswitch to the proper voltage range (220V-240V or110V-120V) of your area.Consult your dealer if you are unsure of the correctsetting.WARNINGBe sure to unplug the subwoofer before setting theVOLTAGE SELECTOR switch correctly.Rear panelm Controls and their functionsINPUT1FROM AMPLIFIEROUTPUTTO SPEAKERSINPUT2 /MONOAUTOSTANDBYSTANDBY-REDON-GREENOFFLOWHIGHOFFPOWERON1VOLUME0 I0OFFPOWERON564INPUT1FROM AMPLIFIEROUTPUTTO SPEAKERSINPUT2 /MONOAUTOSTANDBYSTANDBY-REDON-GREENOFFLOWHIGHVOLUME0 I0237VOLTAGESELECTOR220V-240V110V-120VVOLTAGESELECTOR220V-240V110V-120V8