Yamaha PW50 Owner's Manual

Also see for PW50: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

PERIODIC MAINTENANCE AND ADJUSTMENT7-22710. Pull the wheel to the right to sepa-rate it from the final gear case, andthen remove the wheel.EAU41523To install the rear wheel1. Apply a light coating of lithium-soap-based grease to the splinesof the final gear case and wheelhub.2. Install the wheel by inserting it intothe wheel hub.3. Install the rear arm by installing thewashers and nuts.4. Install the axle nut.5. Install the right-side rear shock ab-sorber by installing the mountingbolt.6. While applying the rear brake,tighten the axle nut to the specifiedtorque.7. Tighten the rear arm nuts and rearshock absorber mounting bolt tothe specified torques.8. Install the exhaust chamber by in-stalling the bolt and washers.9. Install the power reduction plate, anew gasket, and then install theexhaust manifold bolts.10. Tighten the exhaust manifold boltsand exhaust chamber bolt to thespecified torques.11. Install the muffler by sliding thespring clamp up to its original posi-tion, and then installing the wash-ers and muffler bolt.TIPMake sure that the spring clamp is po-sitioned with the projection side facinginward.12. Tighten the muffler bolt to thespecified torque.1. Rear arm2. Washer3. Rear arm nut1 2 3Tightening torques:Axle nut:60 Nm (6.0 m·kgf, 43 ft·lbf)Rear arm nut:29 Nm (2.9 m·kgf, 21 ft·lbf)Rear shock absorber mounting bolt:23 Nm (2.3 m·kgf, 17 ft·lbf)Tightening torques:Exhaust manifold bolt:9 Nm (0.9 m·kgf, 6.5 ft·lbf)Exhaust chamber bolt:18 Nm (1.8 m·kgf, 13 ft·lbf)1. Exhaust chamber2. Spring clamp3. Muffler123U5PG8BE0.book Page 22 Wednesday, June 27, 2012 2:53 PM