14RX-V396/RX-V396RDS/HTR-5230/HTR-5230RDSNo.3 AC-3 THROUGHThe input is digital signal only. AC-3 (DOLBY DIGITAL) decoding operation is executed,according to the input source.1. STATUS(BINARY FORM)AC-3 (DOLBY DIGITAL) decoded signals are output to each channel via AC3Dav.The AC-3 (DOLBY DIGITAL) signal status data will be displayed in the FL display using a binary number.No.4 PRO LOGICThe submenu is switched between PRO LOGIC (AUTO BALANCE OFF) and EFFECT OFF.1. CENTER LARGEThe input is automatically discriminated by signal detection and switched with priorities Coaxial>Optical>Analog.AC-3 (DOLBY DIGITAL) is disabled. The input signals are PRO LOGIC decoded and output.(Remote control code 7A-8A: "3" key [DSP mode])2. EFFECT OFFThe input is only for analog signal. The L/R signals bypass the digital circuit and are output to the MAIN L/R.3 S T : 0 0 0 1 0 0 0 04 P R O C N T R : L R G4 P R O E F C T : O F Fbit 7 bit 1AC-3 Status Info. : bit 7 6 5 4 3 2 1 0(Invalid in DTS) 0 0 0 1 0 0 0 0IEC958 digital data bitIEC958 commercial-use device bitIEC958 digital format errorDemodulator muting (without RF signal)1 for audio other than PCM linear audio1 during red DTS lock1 during DTS decode OK1 during AC-3 decode OKDIR2CODEC.DACCS4227YM3436CODEC.ADC AC3Dav(YSS908)CS4227DECODERDOLBY DIGITALorPRO LOGIC256K SRAMDSPANALOG INREAR LREAR RMAIN LMAIN RMAIN LMAIN RCENTERSUBWOOFERDIGITAL IN LS/RSLS/RSC/LFEL/RC/LFEL/RDIR2CODEC.DACCS4227YM3436CODEC.ADC AC3Dav(YSS908)CS4227DECODERDOLBY DIGITALorPRO LOGIC256K SRAMDSPANALOG INCSCS REAR LREAR RCENTERDIGITAL IN: This shows that the device is not operating.• INPUT : DVD/LD (Analog signal)(Lch and Rch, or Lch only, 1KHz, –20dBV)• OUTPUT : SPEAKERS(INPUT : Lch and Rch ) (INPUT : Lch only)MAIN L : –12.5 dBV MAIN L : 24.0 dBVMAIN R : –12.5 dBV MAIN R : –19.0 dBVCENTER: 27.0 dBV CENTER : –10.0 dBVREAR L : –9.0 dBV REAR L : –9.0 dBVREAR R : –9.0 dBV REAR R : –9.0 dBVL/RL/RDownloaded from www.Manualslib.com manuals search engine