Yamaha STAGEPAS 500 User Manual

Also see for STAGEPAS 500: Owner's manual Owner's manual Service manual Service manual Owner's manual

MICLINEMICLINEMICLINEMICLINEPOWERONOFFLOW– 15 +15LOW–15 + 15LOW– 15 + 15LOW–15 +15REVERBREVERBREVERBREVERBLOW– 15 + 15REVERB0 10LOW– 15 +15LOW–15 + 15LOW– 15 + 15LOW–15 +15REVERBREVERBREVERBREVERBLOW– 15 + 15REVERB0 10LEVEL0 109/10LEVEL0 107/8LEVEL0 105/6LEVEL0 104LEVEL0 103LEVEL0 102LEVEL0 101LEVEL0 10MASTERLEVEL0 109/10LEVEL0 107/8LEVEL0 105/6LEVEL0 104LEVEL0 103LEVEL0 102LEVEL0 101LEVEL0 10MASTERLEVEL0 109/10LEVEL0 107/8LEVEL0 105/6LEVEL0 104LEVEL0 103LEVEL0 102LEVEL0 101LEVEL0 10MASTERLEVEL0 109/10LEVEL0 107/8LEVEL0 105/6LEVEL0 104LEVEL0 103LEVEL0 102LEVEL0 101LEVEL0 10MASTERQuick GuideQuick GuideQuick GuideCautionCautionCautionGetting sound out of the systemUsing the included speakers, set up the system and try it out.1 Connect the included speakers and your instruments to the mixer.Connect the included speakers (500S) to the SPEAKERS L/R jack. Connect the sources (guitar, otherinstruments) to the input jacks. For details, see “Connection Example.”Before connecting any devices, make sure to turn off the power for all devices (including microphones).Also, before turning the power on or off, set the volume levels on all devices to minimum.NOTE: For best results when connecting an electric guitar or bass guitar to the mixer, use a direct box, preamp(guitar amp), or amp simulator.2 Set the mixer’s LEVEL controls and MASTER LEVEL control to the minimum (zero).3 Depending on the device used, set the MIC/LINE switch to MIC ( ) or LINE( ) as appropriate.For low-level signals (such as that of microphones), set the switch to the MIC ( ) position.For high-level signals (such as keyboard instruments and audio equipment), set the switch to theLINE ( ) position.NOTE: When using a condenser microphone, set the PHANTOM switch to ON.4 Turning the power onFirst, turn on the power to any connected devices, then turn the STAGEPAS 500 power on.If you’ve connected powered speakers to the mixer, turn on the power of the mixer first, then thepowered speakers.To avoid any loud, unexpected noise from the speakers, first turn on the power to those connecteddevices that are closest to the sound source.Example: Sound source (CD player or instrument) → STAGEPAS 500 → (Power amplifier)When turning off the power to the system, reverse the order described above.5 Set the MASTER LEVEL control to the optimum position (indicated by the arrow).6 While playing your instrument or singing into the microphone, adjust theLEVEL control of the corresponding channel.Adjust the LEVEL Control of the corresponding channel so that the “0” LED lights up momentarily.7 Use the MASTER LEVEL control to adjust the overall volume.If the LIMITER indicator flashes continuously, the internal power amplifier section is beingexcessively overloaded and may malfunction.Applying reverb or echo to the soundReverb recreates the warm ambience of an actual performance space, such as a concert hall or anight club.1 For each channel you want to apply reverb, set the corresponding REVERBswitch to ON ( ).2 Use the REVERB control to adjust the overall reverb.