4EnSPECIFICATIONSType ............................. 2-way bass reflex speaker systemMagnetic shielding typeDriver ...................................... 13 cm (5”) cone woofer x 23 cm (1”) Aluminum dome tweeterImpedance ................................................................... 6 ΩFrequency Response ................. 56 Hz to 50 kHz (–10 dB)to 100 kHz (–30 dB)Nominal Input Power .................................................. 40 WMaximum Input Power ............................................. 200 WSensitivity .................................................. 89 dB/2.83 V/mCrossover Frequency ................................................ 3 kHzDimensions (W x H x D) ..................... 500 x 170 x 271 mm(19-11/16” x 6-11/16” x 10-11/16”)Weight ................................................... 8.6 kg (18.15 lbs.)• Specifications subject to change without notice due toproduct improvements.• Care should be taken not to exceed the input powervalues noted above.ATTACHING THE FRONT COVERThe speaker and the front cover are packed separately.To attach the front cover, line up the four salients (magnet)on the reverse side of the front cover with the fourcorresponding pegs.Notes• When the cover is not attached, take care not totouch the speaker units with your hands or to exertexcessive force with tools.• There are magnets on the reverse side of the frontcover. Do not place the front cover close to objectsthat might be affected by magnets, such as TVs,clocks, magnetic cards, diskettes etc. when youdon’t use it. Taking care of the speakerWhen you wipe this unit, do not use chemical solvents(ex. alcohol or thinners etc.); this might damage thefinish. Use a clean, dry cloth. For heavy dirt, dampen asoft cloth in detergent diluted with the water, wring it out,and then clean this unit up with a soft cloth.