Yamaha Stagepas 500 Service Manual

Also see for STAGEPAS 500: Owner's manual Owner's manual Service manual Owner's manual User manual

Contents

14STAGEPAS 50015-8 Remove the five (5) screws marked [110]. TheCONTROL2 (2/3) circuit board can then beremoved. (Photo 23)* The following parts are not parts of theCONTROL2 (2/3) circuit board. When replacingthe CONTROL2 (2/3) circuit board, be sure toremove these parts and attach them to the newCONTROL2 (2/3) circuit board. (Photo 24)• [40]: Push buttons 7 pcs.• [50B]: Volume knob (S) (white) 1 pc.• [60]: Volume knobs (S) (green) 14 pcs.• [70]: Volume knob (S) (blue) 1 pc.16. Power Switch, AC Inlet(Time required: About 5 minutes)16-1 Remove the mixer assembly. (See procedure 6)16-2 Remove the rear case. (See procedure 8)16-3 Remove the shield bracket 2. (See procedure 9)16-4 Remove the shield bracket 1 assembly.(See procedure 13)16-5 Remove the two (2) connector assemblies(connector assembly (1P) and connector assembly(2P)) and earth wire soldered to the power switchand AC inlet. (Fig. 3)16-6 Remove the power switch by pressing its claws. (Fig. 4)16-7 Remove the AC inlet by pressing its claws. (Fig. 5)17. Fan (Time required: About 5 minutes)17-1 Remove the mixer assembly. (See procedure 6)17-2 Remove the rear case. (See procedure 8)17-3 Remove the shield bracket 2. (See procedure 9)17-4 Remove the shield bracket 1 assembly.(See procedure 13)17-5 Remove the four (4) screws marked [210]. The fancan then be removed from the shield bracket 1assembly. (Photo 25)* The fan is fixed with two-sided tape. Applypower little by little to remove the fan.CONTROL2 (2/3)[110][110]Photo 23 ( )[40]: Push button ( )[40]: Push button( )[70]: Volume knob (S) (Blue) ( (S)( ))[60]: Volume knob (S) (Green)( (S)( ))[50B]: Volume knob (S) (White)( (S)( ))CONTROL2 (2/3)Photo 24 ( )www . xiaoyu163. comQQ 376315150 992894298TEL 13942296513 992894298051513673QQTEL 13942296513 QQ 376315150 892498299TEL 13942296513 QQ 376315150 892498299http://www.xiaoyu163.comhttp://www.xiaoyu163.com