Yamaha YST-SW325 Owner's Manual

Also see for YST-SW325 - Subwoofer - 170 Watt: Service manual

Contents

4Choose one of the following two connecting methods that is more suitable for your audio system.Choose (pages 4-5) if your amplifier has line output (pin jack) terminal(s)Choose (pages 6-7) if your amplifier has no line output (pin jack) terminalCaution: Do not connect the power cord of the subwoofer and other components into an ACoutlet until all connections between components are completed.NoteAll connections must be correct, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to theowner’s manual of your component to be connected to the subwoofer.• To connect with an amplifier (or AV receiver), connect the SUBWOOFER (or LOW PASS etc.) terminal on the rear ofthe amplifier (or AV receiver) to the /MONO INPUT2 terminal of the subwoofer.• When connecting the subwoofer to the SPLIT SUBWOOFER terminals on the rear of the amplifier, be sure to connectthe /MONO INPUT2 terminal to the “L” side and the INPUT2 terminal to the “R” side of the SPLITSUBWOOFER terminals.Notes• Some amplifiers have line output terminals labeled PRE OUT. When you connect the subwoofer to the PRE OUTterminals of the amplifier, make sure that the amplifier has at least two sets of PRE OUT terminals. If the amplifier hasonly one set of PRE OUT terminals, do not connect the subwoofer to the PRE OUT terminals. Instead, connect thesubwoofer to the speaker output terminals of the amplifier. (Refer to pages 6-7.)• When connecting to a monaural line output terminal of the amplifier, connect the /MONO INPUT2 terminal.• When connecting to line output terminals of the amplifier, other speakers should not be connected to the OUTPUTterminals on the rear panel of the subwoofer. If connected, they will not produce sound.CONNECTIONS12Connecting to line output (pin jack) terminals of the amplifier1LL RL