Yanmar BY series Installation Manual

Also see for BY series: Service manual Service manual

Contents

Yanmar BY series Installation Manual Manual pdf 8 page image

Electronic Control System: Installation Manual for BY Series Engines with Classic Controls Page Run the engine harness from the helm to the transom area. The engine harness has three main connectionpoints, the helm, the transom and the engine.Attach the transom breakout point to the transom near the centerline of the engine and high enough that you canaccess this point after the installation is complete. Make the following connections and dress the wires.• Gear Oil Return (Black) and Gear Oil (Brown) connect to the Gear Oil Reservoir. Tie back when usingMarine Gear.• Trim Position Return (Black) and Drive Trim Position (Dark Blue) connect to wires from the transom plate.Tie back when using Marine Gear.• Fuel Return (Black) and Fuel (Pink) go to the fuel sender.• Tie the J7 NMEA connector back at this time. This connector is supplied for future NMEA 2000 connections.Leave the helm end and the engine end disconnected at this time.CE500xx Helm End CE500xx Transom Breakout CE500xx to EngineRoute the Shift CableMount the shift plate that came with the stern drive near the stern drive transom plate and route the shift cable fromthis area to the helm where the control will be mounted. Connect the stern drive lower leg cable and the cable thatgoes to the shift control. The upper cable goes to the helm and the lower cable goes to the stern drive.Shift PlateInstallation