Yard Machines 430 Series Operator's Manual

Also see for 430 Series: Operator's manual Operator's manual Operator's manual

Contents

Yard Machines 430 Series Operator's Manual Manual pdf 11 page image

11Blade Control HandleWARNING: This control mechanism is asafety device. Never attempt to bypass itsoperations.The blade control handle is located on the upper handleof the mower.The blade control handle must bedepressed in order to operate the unit. Release theblade control handle to stop the engine and the blade.Recoil StarterThe recoil starter handle is attached to the handle andis used to start the engine.Grass CatcherThe grass catcher, located at the rear of the mower, isused to bag the grass clippings for disposal at anothersite. Once the bag is full, it has to be removed from themower and emptied before any further mowing.Mulching PlugBoth the mulching baffle and the mulching plug areused only for mulching purposes. Instead of collectingthe grass clippings in a grass catcher, some mowermodels have the option of recirculating the clippingsback to the lawn. This is called mulching.Throttle ControlYour unit is equipped with one of three throttle controlsdescribed below. Follow instructions which pertain toyour unit.1. The throttle control is located on the left side of theupper handle. It is used to regulate the enginespeed.2. The throttle control is located on the engine. It isused to regulate the engine speed.3. Your engine is equipped with a constant speedthrottle, which is set at full throttle for bestperformance.WARNING: The throttle control cannot beused to stop the engine. If the throttlecontrol is located on the engine, do notadjust it with the engine running.Cutting Height Adjustment LeverThis lever, located at each wheel, lets you adjustcutting height of the grass. Remember to put all fourlevers at the same height to avoid uneven cut.SECTION 5: OPERATING YOUR LAWN MOWERWARNING: Keep hands and feet awayfrom the chute area on cutting deck. Theblade will be rotating whenever the engineis running.NOTE: For shipping purposes your mower is set withthe wheels in a low cutting height position. For bestresults, raise the cutting position until it is determinedwhich height is best for your lawn. Refer to instructionsfor cutting height adjustment on page 12.Gas and Oil Fill-UpService the engine with gasoline and oil asinstructed in the separate engine manual packed withyour mower. Follow instructions carefully.WARNING: Never fill fuel tank indoors,with engine running or until the enginehas been allowed to cool for at least twominutes after running.Before Starting• Attach spark plug wire to spark plug. If unit isequipped with a rubber boot over the spark plugwire, ensure that the metal cap on the end of thespark plug wire (inside the rubber boot) is fastenedsecurely over the metal tip on the spark plug.To Start Engine and Engage Blade• Move throttle control lever (if equipped) to the fast(rabbit) position.• If engine is equipped with a primer, prime engine asinstructed in the separate engine manual packedwith your unit.• Standing behind the unit, depress the blade controlhandle and hold it against the upper handle.• Grasp starter handle and pull rope out slowly untilengine reaches start of compression cycle (ropewill pull slightly harder at this point). Let the roperewind slowly.• Pull rope with a rapid, continuous, full arm stroke.Keep a firm grip on starter handle. Return it slowlyto the rope guide.NOTE: If any problems are encountered, refer to theTrouble Shooting Guide.To Stop Engine and Blade• Release the blade control handle to stop the engineand blade.WARNING: The blade continues to rotatefor a few seconds after engine is shut off.