Yazoo/Kees ZEKW42170, ZEKW52210 Operator's Manual

Also see for Z9 Commercial Collection System Z9A: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Contents

Yazoo/Kees ZEKW42170, ZEKW52210 Operator's Manual Manual pdf 55 page image

English- 53LUBRICATIONLubricating the CablesIf possible, grease both ends of the cables and move the controls to end stop positions when lubricating.Refit the rubber covers on the cables after lubrication. Cables with sheaths will bind if they are notlubricated regularly. If a cable binds, it can disrupt operation.If a cable binds, remove the cable and hang it vertically. Lubricate it with light engine oil until the oil beginsto escape from the bottom.Tip: Fill a small plastic bag with oil and tape it so that it seals against the sheath and allow the cable to hangvertically from the bag overnight. If you do not succeed in lubricating the cable, it must be replaced.Lubricating in Accordance with theLubrication Schedule1. Front Wheel MountLubricate with a grease gun, one zerk foreach wheel mount, until the grease is forcedout.Use only good quality bearing grease.Grease from well-known brand names(petrochemical companies, etc.) usuallymaintains a good quality.2. Front Wheel BearingsLubricate with a grease gun, one zerk for eachset of wheel bearings, until the grease is forcedout.Use only good quality bearing grease.3. Deck spindleLower the cutting deck completely.If you use grease gun without rubber hose,the foot plate must be removed.Lubricate with a grease gun, one zerk,2-3 strokes.Use only good quality bearing grease.8011-731Lubricating the front wheels8011-732Deck spindleIMPORTANT INFORMATIONUse minimal lubrication and remove excesslubricant so that is does not come intocontact with belts or belt pulley drivesurfaces.