Yealink CP930W-Base Quick Start Manual

Also see for CP930W Telesystem: Quick user guide Quick start guide Quick reference guide Quick start guide User guide

Contents

Yealink CP930W-Base Quick Start Manual Manual pdf 6 page image

Note:• If the CP930W is registered to the base station successfully, the LCD screen prompts“Handset Subscribed” and “Base NO.”( the “NO.“ indicates the last 4 characters of the basestation’s MAC address).• If the CP930W LCD screen prompts “Searching for Base”, check that your base station ispowered on.Network SettingsYou can configure the base station to obtain network settings in one of the following ways:DHCPBy default, the base station attempts to contact a DHCP server in your network to obtain the val-id network settings, such as IP address, subnet mask, gateway address and DNS address.StaticIf the base station cannot contact a DHCP server for any reason, you need to configure the IPaddress, subnet mask, gateway address, primary DNS address and secondary DNS address forthe base station manually.To configure the network parameters for the base station manually:1. Tap Menu->Settings->Advanced Settings (default PIN: 0000)->Network->Basic.2. Select the desired IP addressing mode from the IP Mode field.3. Select the desired IP addressing mode.4. Make the desired changes.5. Tap the Save soft key to accept the change.Note:• The DECT conference phone supports either or both IPv4 and IPv6 addressing modes, butIPv6 is disabled by default.• Wrong network settings may result in inaccessibility of your phone and may affect thenetwork performance. Contact your system administrator for the network parameters.Turning CP930W On/OffTo turn the CP930W on, do one of the following:• Long tap , wait until the LCD screen lights up.• Place the CP930W in the charging cradle. The CP930W will be turned on automatically.To turn the CP930W off:5Basic Operations