Yealink DECT RT10 User Manual
Also see for DECT RT10: SpecificationsDeployment guide
    |
www.yealink.comThe flow diagrams of these two registration methods are shown below:Base StationLong press pagingkeyRepeaterLED stays onRepeaterSwitch onRepeaterLED flashesReady for useRepeaterSwitch offHandsetEnable repeater modeBase StationSwitch on1. Switch off the repeater (disconnect the power adapter).2. Switch it on for 1 to 5 seconds and switch it off again.3. Switch it on again. The LED indicator on the repeater flashes slowly.4. Switch it off again.5. Switch it on again.The verification tone is then activated.To find the best possible location for the repeater, you may need to try various locations.Place a call and walk around with the handset to determine the base station’s coveragearea. The verification tone allows you to easily check the extent of the repeater’scoverage area. The tone is audible on the handset during a call.Place a call using the handset to check whether the handset is working in the extendedarea of the repeater. If the call is successfully handled by the repeater, you can hear theverification tone from the handset every few seconds.DECT Repeater RT10 User GuideHandsetEnable repeater modeBase StationSwitch onReady for useBase StationSet password to 0000RepeaterSwitch on (1-5s) andoffRepeaterLED flashes withoutinterruptionsHandsetDial out #*9Base StationHandsetPress number (2-7)and * keyHang upRepeaterLED stays onLong press pagingkeyRepeaterSwitch on againNo RepeaterLED flashes withinterruptionsHandsetRe-register to basestationRepeaterLED flashes withoutinterruptions |
Related manuals for Yealink DECT RT10
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine