Yealink SIP-T38G Quick Installation Manual

Also see for SIP-T38G: Auto provisioning guide User guide User guide Admin guide Administrator's guide

Yealink SIP-T38G Quick Installation Manual Manual pdf 1 page image

Click on -> (X=1,2,3,4,5,6)(V70.2)www.yealink.comPlease locate your computer in the same network segment of the IP phone (192.168.0.X) to access theWeb user interface. Contact your system administrator for more information.Check with your system administrator if any error appears during the registration process or if a specificconfiguration is required for your registration.The wrong network settings may result in inaccessibility of your phone and may have an impact on thenetwork performance. Contact your system administrator for more information.1. Press the key when the phone is idle to get the IP address of your phone.You can configure the network settings in the following ways:It shows the register status of the current account.You can select Enabled/Disabled to enable/disable the account.It is shown on the LCD to identify the account.It is shown as Caller ID when placing a call.It is provided by ITSP for registration (required).It is authenticated ID for authentication provided by ITSP (required).It is provided by ITSP for registration (required).It is provided by ITSP for registration (required).: By default, the phone attempts to contact a DHCP server in your network in order to obtainits valid network settings, e.g. IP address, subnet mask, gateway, DNS server.: If your phone can not contact a DHCP server for any reason, you need toconfigure IP address, subnet mask, default gateway, primary DNS and secondaryDNS for the phone manually.: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoEmode. Contact the ITSP for the account and password.Press the soft key when the phone is idle, select ->-> -> to configure the network settings.Press the soft key when the phone is idle, select ->-> to configure the account settings.2. Open the Web browser of your computer, enter the IP address into the address bar (e.g."http://192.168.0.10" or "192.168.0.10") and click .Register Status:Account Active:Label:Name:User Name:Register Name:Password:SIP Server:3. Enter the user name (default: admin) and password (default: admin) in the pop-up dialoguebox and click .Click on -> ->Refer to for the parameter informantion.Registered Register Fail RegisteringFor more information, refer to the User Guide available online:Copyright 2014 YEALINK NETWORK TECHNOLOGY CO.,LTD.c(V70.3)

/ 2

Related manuals for Yealink SIP-T38G