Yealink SIP-T42G Quick Start Manual

Also see for Yealink SIP-T42G: Developer's guide Administrator's guide Manual Auto provisioning guide Getting started

Contents

ENGLISH3Configuring Your PhoneConfiguring via web user interfaceAccessing the web user interface:1. Press the OK key when the phone is idle to obtain the IP address of the phone.2. Open the web browser on your computer, enter the IP address into the address bar(e.g.,“http://192.168.0.10” or “192.168.0.10”), and then press the Enter key.3. Enter the user name (default: admin) and password (default: admin) in the login page and clickConfirm.Network Settings: Click on Network->Basic->IPv4 ConfigYou can configure the network settings in the following ways:DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its validnetwork settings, e.g., IP address, subnet mask, gateway address and DNS address.Static IP Address: If your phone can not contact a DHCP server for any reason, you need toconfigure the IP address, subnet mask, gateway address, primary DNS addressand secondary DNS address for the phone manually.Note: The wrong network settings may result in the inaccessibility of your phone and may have an impact onthe network performance. Contact your system administrator for more information.Account Settings: Click on Account->Register->Account X (X=1, 2, 3)Parameters of the account:Register Status: It shows the register status of the current account.Line Active: You can select Enabled/Disabled to enable/disable the account.Label: It is shown on the LCD to identify the account.Display Name: It is shown as Caller ID when placing a call.Register Name: It is an authenticated ID for authentication provided by ITSP (required).User Name: It is provided by ITSP for registration (required).Password: It is provided by ITSP for registration (required).Server Host: It is provided by ITSP for registration (required).Register status icons on the LCD screen:Registered Register Failed RegisteringNote: Check with your system administrator if any error appears during the registration process or a specificconfiguration is required for your registration.Configuring via phone user interfaceNetwork Settings:Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (password:admin)->Network->WAN Port/VLAN/Webserver Type/802.1x Settings/VPN to configure thenetwork.Account Settings:Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (password:admin)->Accounts to configure the account.Note: For more information on account parameters, refer to Configuring via web user interface.