Quick Reference GuideYealink T42G & T42S Phones Green PlatformAdvanced Call HandlingBlind Transfer (Unannounced)Blind transfers pass through the caller ID of the originating caller to the third party.• Press the Tran soft key to place the first call on hold• Input the destination extension or phone number• Press the Tran soft key to complete the transferTransfer directly to an internal voicemail box by dialing 7 plus the extension as the destination numberAnnounced Transfer• Press the Tran soft key to place the first call on hold• Input the destination extension or phone number. Remain on the line while the secondcall connects.• To complete the transfer after speaking with the third party, hang up or pressthe Tran soft key.• To cancel the transfer and go back to the first party, press the Cancel orEndCall soft key. Your first call will still be on hold.2700 Oregon Road • Northwood, OH 43619 | 1645 West Chester Pike • West Chester, PA 19382 • 1.888.808.6111 | www.telesystem.us5.11.18Available features may vary. Particular feature set is based on the original order and the systemadministrator’s requests for each deployment. Please contact your system administrator orTelesystem directly to discuss any additions to the system.Call Handling BasicsAnswer a callLift the handset then begin speaking to the caller.Place a callLift the handset then enter the phone number, extension, or code you wish to dial. PressSend to initiate the call or wait for it to go through.End a callHang up the handset or press the End Call soft key.MutePress the mute button to mute your audio while on a call. Press again to disengage.SpeakerPress the speaker button to use speaker audio mode.HeadsetPress the headset button to use headset mode audio (must have a headset attached).VolumePress the volume buttons to adjust volume for your ringer when idle or audiomode while on a live call.HoldPress the Hold soft key to place an active call on hold.To resume a call,• When only one is on hold, press the Resume soft key.• When there is more than one on hold, use the and buttons to select thedesired call then press the Resume soft key.