Yealink VC800 Administrator's Manual

Also see for MeetingSpace VC500: Administrator's guide Administrator's guide Administrator's guide Administrator's guide Quick configuration guide

Administrator’s Guide for Yealink VC800&VC500 Video Conferencing System1823. Select the desired values from the pull-down lists of Far Control Near Camera.4. Click Confirm to accept the change.To configure far control near Camera feature via the remote control:1. Select More->Setting->Video & Audio.2. Check the Far Control Near Camera checkbox3. Press to exit.Camera Control ProtocolVC800/VC500 video conferencing system supports camera control protocols: FECC (Far EndCamera Control). You can enable the FECC protocol for SIP call or H.323 call.If far site wants to control the local camera, both the far site and near site should enable thecamera control protocol simultaneously. If the FECC protocol is not enabled on either site,far-end camera control cannot be performed. For example, a SIP call is established between twosites, the two sites must enable FECC (SIP) protocol simultaneously to perform far-end cameracontrol. If FECC (SIP) protocol and FECC (H.323) protocol are both enabled, the system will selectthe appropriate camera control protocol according to the protocol (SIP or H.323) the call uses.Camera control protocol parameters are described below:Parameter Description Configuration MethodFECC(H.323)Enables or disables the FECC (H.323)protocol for far site to control nearcamera. You can configure it for theStarLeaf Cloud platform or H.323 callseparately.Default: EnabledWeb User Interface