Yealink W60B Quick Start Manual

Also see for W56H: User guide Quick start guide User guide How to configure Quick start guide

Contents

Yealink W60B Quick Start Manual Manual pdf 6 page image

Network SettingsDHCPYou can configure the base station to obtain network settings in one of the followingways:5Easy Registration:Normal Registration:Handset RegistrationYou can register up to 8 handsets to one W60B base station. Each handset can beregistered to 4 different base stations.When the handset LCD screen prompts “Press base paging 2s then press Reg.”, longpress on the base station till the registration LED flashes. There are two methodsto register a new handset:1.Press the OK soft key on the handset, and then select Register Handset.2.Select the desired base station and then press the OK soft key. The handset beginssearching the base station.3.Press the OK soft key after searching a base station successfully.4.Enter the base station PIN (default: 0000), and then press the Done soft key tocomplete registration.1.Press the Reg soft key on the handset to register quickly.To register to multiple base stations, press the OK to enter the main menu, and selectSettings->Registration->Register Handset, then repeat steps 2-4.Note: If the handset is registered to the base station successfully, the handset LCDscreen prompts “Handset Subscribed” and “Base NO.”( last 4 characters indicatethe base station’s MAC address).If the handset LCD screen prompts “Searching for Base”, check if your basestation is powered on or not.By default, the base station attempts to contact a DHCP server in your network toobtain the valid network settings, e.g., IP address, subnet mask, gateway address andDNS address.