76EN1.b1.e 2. 5.b 5.c 5.d1.c1.a1.dBefore assembly, remove the plasticcovers from both front and rear wheelaxis.Handlebar and front fork installation:Remove the sleeve cover, the sleeveitself and upper the headset ringfrom the front fork. At installation,the headset composition must be ason the picture.Put the sleeve cover (1) on the handlebartube and place it into the fork tube (2).Adjust the heigh as desired (do notexceed the maximum mark) and tightenthe screw on the sleeve (3).In the end, place the protective coverover the sleeve.Protective pad installation:Place the soft protective pad fromwashable nylon over the handlebarstem.Check that the pads make enoughspace (1–2 mm) after releasing the brakelevers. The distance can be adjusted bytightening or loosening the brake cableat the anchor screw (2).In case the brake pad is touchingthe wheel when turning, symmetricallyadjust the distance of brake arms bythe tightening screws (3).Insert the front fork into the main frametube (1) so that the bending of the forkfaces forward. Place the upper headsetring (2) and the sleeve (3) back on thefront fork.Place the sleeve screw exactlyon the cut-out of the fork tubeas on the picture.3. 4. 5.aSeat installation:Put the seat tube into the frame (1) ofthe running bike, adjust the desiredheight (do not exceed the maximummark) and tighten the sleeve screw (2).Then inflate the tires according tothe values on their side (ideallybetween 1,5 and 2 bars).Adjustment of brake levers: (OneToo)Incline the brake levers correctly byloosening the screw on the sleeve (1).The right inclination:Let the child sit on the running bike,hold the handles and stretch out yourfingers in a way that his/her arm andthe fingers form a single straight line.This should be the position of the brakelever.Adjustment of brake: (OneToo)When braking, check that the brakepads fit tightly on the rim sides. Theirposition can be adjusted via thescrews (1). The pads shall not touchthe tires.Fasten the end of the brake cable inthe lock and secure with the cable tie,then trim the tie.11223 10 Nm3Assembly Instructions1 1 1226 Nm2Max 115 Nm3 3