356486-UUM-K-06132 Johnson Controls Unitary ProductsINSTRUCTIONS FOR EXAMINING THEFURNACE INSTALLATIONIt is the owner’s responsibility to ensure that an annual inspection of theentire heating portion of the unit is made by a qualified service agency.Examine the furnace as outlined below in steps “1 - 8” before eachheating season. Use Figures 1 - 6 for visual reference.FIRE OR EXPLOSION HAZARDThis furnace is designed and approved for use with Natural Gas and(LP) Propane Gas ONLY. DO NOT BURN ANY LIQUID FUEL ORSOLID FUEL IN THIS FURNACE.Burning any unapproved fuel will result in damage to the furnace heatexchanger, which could result in Fire, Personal Injury, and/or PropertyDamage.FIGURE 1: Component Location - 80% Single & Two Stage Models FIGURE 2: Component Location - 95% Single & 96% Two Stage ModelsVent PipePressureSwitchSiliconeTubeRolloutSafety SwitchGas ValveFlameSensorInduced DraftAssemblyInducedDraft MotorLimitSwitchIgnitorManifold PipeSafetyDoorSwitchControl BoardFlue CollarElectricalJunctionBoxBlowerTransformerCapacitor(Not used on all models)Power FactorChoke(Not used onall models)Vent PipePressure SwitchManifoldPipeRollout Safety SwitchGas ValveFlame SensorManifold DraftAssemblyLimit SwitchIgnitorSafetyDoorSwitchControl BoardElectricalJunctionBoxBlowerTransformerCapacitorCondensate PanSiliconeTube(Not used on all models)Power FactorChoke(Not used onall models)FIGURE 3: Component Location - 80% Modulating PSC Models FIGURE 4: Component Location - 80% Modulating ECM ModelsPressureSensorSiliconeTubeRolloutSafety SwitchGas ValveFlameSensorInduced DraftAssemblyInducedDraft MotorLimit SwitchIgnitorManifoldPipeSafetyDoor Switch ControlBoardFlueCollarElectricalJunction BoxBlowerTransformerCapacitorPSC MOTORPressureSwitch PressureSwitchPressureSensorSiliconeTubeRolloutSafety SwitchGas ValveFlameSensorInduced DraftAssemblyInducedDraft MotorLimit SwitchIgnitorManifoldPipeSafetyDoor Switch ControlBoardFlueCollarElectricalJunction BoxBlowerTransformerPower FactorChokeECM MOTOR(Not used onall models)