14FLOOR/CEILING Indoor Unit FixingCeiling Case1 Lift the indoor unit to the bracket.2 Push the indoor unit to lock at the bracket.Floor Case1 Tighten the bolt to lock indoor unit tobracket floor case.2 Lift the indoor unit, and hang it to the wallbracket.3 Make sure that the unit is correctly hung inplace by sliding it to the left and the to theright. Drain HoseDrain hose can pass through the indoor unitfollow figure below.Installation Procedure (continued)After fixing the indoor unit, open front grille and theninsert refrigerant pipe, drain hose and electric cable fromoutdoor through the wall into the unit case, then connectdrain hose together and arrange it.Note : Do not put the drain hose end into water.Verification of condensate water drainage:Fill the drain pan with water and observe evacuation. Unit Coupling1 Connect electric cable to terminal box.2 Connect refrigerant pipe to flare connector.Ceiling caseFloor caseN 1 2Terminal box Flare connector

installation manual

MCC-MCH/MOC-MOH

Safety Precautions

Part List

Preparation Before Installation

Drilling Measurement

Remote Control Receiving Type Setting

Installation in the Following Places May Result in Trouble

Installation Diagram

Installation Procedure

Indoor Unit

Outdoor Unit

Test Operation

Trouble Shooting Guide

Diagnostic Information Function

Technical Specification

York MCC-MCH 09 Installation Manual

MCC-MCH 09

MCC-MCH 12

MCC-MCH 18

MCC-MCH 25

MCC-MCH 35

MCC-MCH 45

MCC-MCH 55