GENERALThese condensing units are designed for outdoor installationon a roof or at ground level and are manufactured underISO 9001 Quality System Certification.Every unit is completely piped and wired at the factory and isshipped ready for immediate installation. Only the liquid andsuction lines to the evaporator coil, the control wiring and themain power wiring are required to complete the installation.Each unit is dehydrated, evacuated, leak tested and pressuretested at 450 psig (3132 kPa) before being pressurized with aholding charge of refrigerant-22 for shipment and/or storage.All controls are located in the front of the unit and are readily ac-cessible for maintenance, adjustment and service. All wiring(power and control) can be done through the front of the unit.Refer to Tables 7 and 8 for condenser cooling capacities andpower requirements.REFERENCEThis instruction covers the installation and operation of the ba-sic condensing unit. For information on the installation and op-eration of the evaporator blower units, refer to instruction Form550.39-N4YI.Renewal Parts:• Refer to Parts Manual for complete listing of replacementparts on this equipment.All forms may be ordered from:Standard RegisterToll Free Telephone: 405-691-1126Toll Free Fax: 405-799-7746INSPECTIONAs soon as a unit is received, it should be inspected for possibledamage during transit. If damage is evident, the extent of thedamage should be noted on the carrier's delivery receipt. Aseparate request for inspection by the carrier's agent should bemade in writing. See Local Distributor for additional information.Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make theinstallation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injuryand/or equipment damage may result if installation procedure is not handled properly.MODELS H6CE090 & H4CE120(WORLD 50 HZ)®INSTALLATION MANUALSUNLINE 2000™ SPLIT-SYSTEMCONDENSING UNITS(AIR COOLED)Supersedes: 035-15406-001-B-0404 035-15406-002-A-0504CAUTIONTHE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLELOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIM ITEDTO, BUILDING, ELECTRICAL, AND M ECHANICAL CODES.THIS PRO DUCT M UST BE INSTALLED IN STRICT CO M PLIANCE W ITHWARNINGOPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURYO R P R O P E R T Y D A M A G E .INCORRECT INSTALLATION M AY CREATE A CONDITION W HERE THEHCE090SHOWN