Youngman Richardson & Co Mikasa Sangyo MVH-206 Instruction Manual
                                | |
Contents
| 
11GripWing nutFig.37. Inspection Before OperationClean each part of the machine well to maintain dirt anddust-free condition. Pay special attention to the soilattached to the bottom of the compacting board, enginecooling air inlet, and the carburetor and air cleaner areato keep those parts clean.Check each part for any looseness of bolts. Vibrationcauses bolts to loosen, which might result inunexpected accident or malfunction.Inspect the guard hook, belt cover and anti-vibrationrubber to check the function of speed adjustment wireand speed adjusting lever.Check for oil leakage from the hydraulic pump andhoses.Check the V-belt tension. (See p.19.) The belt shouldhave about 10 15mm of flexibility when pushedstrongly with a finger at the mid-point between theaxes. If the V-belt is loosened, power is not transmittedwell, which reduces compacting force and shortens thelife of the V-belt.Set the engine on a level surface to check the oil level.If the oil level is low, add oil. Use the following engineoil.Quality: Diesel engine oil, Grade CC or aboveGasoline engine oil, Grade SE or aboveViscosity: SAE No. 30 at 20°C and above (summer)SAE10W-30Set the machine on a level surface, then remove the oilgauge of the vibrator. Check the oil gauge to see if theoil is at the specified level. Use engine oil SAE10W-30as lubrication oil.Recommended oil quantity for MVH-206/207/306/406is 600cc. (Fig. 2-1, 2-2)RefuelingDo not expose to open flames while refueling.Do not fill to the rim because the fuel might spill.Wipe off well if a spill occurs.Use clean automotive gasoline or automotive light oilappropriate for the engine. Let the fuel run through afilter when refueling.㻌㻌㻌㻌㻌㻌Adjusting Handle heightThe height of the handle is adjustable for your comfort.Loosen the wing nut.Turn the grip clockwise to raise the handle or counterclockwise to lower the handle.When the handle is raised to the desired height, tightenthe wing nut.㻝㻞㻟㻠㻡㻢㻣㻤䚷䞉䚷䞉䚷䞉㻥Upper levelLower level(refil needed) Oil gaugeFig.1�)'4Მ㻔㻝㻞㼙㼙㻕Oil gaugeDrain Plug(14mm wrench)Fig.2-2㻱㼒㼒㼑㼏㼠㼕㼢㼑㻢㻜㻜㼏㼏(19mm wrench)For MVH-306/406Just tap on tomeasureoil volume(14mm wrench)(IIHFWLYH)RU09+㻹㼑㼍㼟㼡㼞㼑 㼛㼕㼘㻌㼢㼛㼘㼡㼙㼑Oil gaugeJust tap on tomeasureoil volumeFig.2-1FFDo not move travel leverif engine stops |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine