• When using in bright conditions (early morning or late evening), do not leave the device onwith the objective lens cap open for more than 30 minutes. Continuous observation of brightstationary objects can cause the electronic-optical converter to fade, leading to the appearanceof dark spots in the field of vision.• Do not forget to turn off the scope after each use!• Store with the lens cap on, in the accompanying carrying case.• The scope has been reinforced with an IPX6 rating against water intrusion and can be used ininclement weather; however, it is not intended for full submersion.• Attempting to disassemble or repair the scope will void the warranty!• Clean the scope's optical surfaces only if necessary, and use caution. First, remove (by blowingor carefully wiping off) any dust or sand particles. Then proceed to clean by using a soft cottontissue and alcohol or a cleaning solution approved for use with multicoated lenses. Do not pourthe solution directly onto the lens!• The scope can be used in operating temperatures, ranging from -30°C to +40°C. However, if ithas been brought indoors from cold temperatures, do not turn it on for 3 to 4 hours.• If the riflescope is unable to mount onto the rifle securely, or if there are doubts about themounting system, see a qualified gunsmith. Using the weapon with a poorly mounted scope canlead to inaccurate target shooting!• To ensure reliable performance, it is recommended to carry out regular technical inspections ofthe unit.BATTERY INSTALLATION• Unscrew the cap (1) of the battery compartment counter-clockwise.• Install one AA (1.5V) or CR 123 (3V) battery, so that the (+) and (-) match the markings on thebody of the unit.• Tighten the cap (1).OPERATING THE PHANTOM• Install the batteries according to the directions in the section entitled “BATTERYINSTALLATION”.• Enter a dark environment.• Remove the objective lens cap by sliding it up on top of the objective lens (2).• Turn on the unit by turning the selector switch (3) to the “ON” position; you will see thescreen of the electronic-optical converter light up green.• The scope can also be checked in an illuminated area, but this is meant solely for testing thedevice; the lens cap (2) must tightly cover the objective lens.• To adjust the brightness of the red reticle, turn knob (4).• To select one of the five (three - if EPM66G-2 tube employed) types of red reticles, pressbutton (5).• Choose a removed stationary object to observe, at a distance of about 100 m.• Turn the focusing knob (6) to “100”, it will settle into a notch.• Observe the object through the scope and turn the diopter focus knob (7) until the imageappears crisp.• If necessary, turn on the IR illuminator by turning the selector switch (3) to “IR” position.• Turn the knob of the IR illuminator (8) until you get a focused IR spot.• After making these adjustments, no further tuning of the diopter is required, regardless ofdistance or other factors; perfect the image quality using only the knob for the objective lens (6)and that for the IR illuminator (8).