Operation manual of ZBL-R800, ZBL-R630, ZBL-C310AHotline: (86)010-51290405 Fax: (86)010-5129040618During the process of data transmission, rebar data and corrosion datais transmitted respectively. User selects data for transmission manually;storage file for rebar data is with the ext. name “.801” while rust datais “.802”.Figure 3-2 Data output option3.2.1 USB transmission(A)USB transmission option (B)USB transmissionFigure3-3 USB transmissionPlugging the U-disk attached with instrument into USB port of the leftside paddle, and then selecting “Data Output” in the option interfaceas shown in figure 3-2, pressing 【a】,【b】for USB Trans., and thenpress【ENTER】to enter “USB Options” interface as figure 3-3A.Selecting Trans. Rebar Data or Trans. Rust Data below USBtransmission interface, and then pressing 【ENTER】, instrument willstart up U-disk power supply automatically. When transmissioncompleted and “please plug out U-disk” present, unplugging U-diskfrom USB port of detector, and then pressing any key to go back toUSB transmission option interface. For usage of software analysis,