ZDC ZAP-680 Quick Setup Manual

Contents

quick setup guide

ZDC ZAP-680 Quick Setup Manual Manual pdf 1 page image

ZAP-680 802.11acSmart Access PointQuick Setup GuideThis Quick Setup Guide provides step-by-step instructions on how to set up yourZAP-680 Smart Access Point. Aftercompleting the steps described in thisguide, you will be able to place the AP atyour site and provide wireless networkaccess to users.PACKAGE CONTENTSHARDWARE OVERVIEWFront ViewNo LED State Description1 PWR On(Green)Power is beingsupplied to thedevice2 SYS On(Amber)Device ready.Ethernet portconnected.Off Ethernet port notconnected.3 WLAN Blinking(Green)2.4G radio enabledor data beingforwardedOff 2.4G radio disabledBlinking(Amber5G radio enabled ordata beingforwardedOff 5G radio disabledLED Indicators on the Device• ZAP-680 smart access point (1)• DC power cord & PoE Injector (1)• Mounting screws and brackets (2)• A4 paperSETUP REQUIREMENTSBefore installing your ZAP-680 access point, besure that you have the following:• A computer running Windows 7, Vista, or XP• A CAT5 UTP cable of required length• One of the following power sources:- IEEE 802.3at-compliant power over Ethernet(PoE) source- Power adapter came with the packageNote:If the AP is deployed with a AP controller, pleasefollow the section INSTALL THE AP to proceed.STEP 1: POWER ON THE APThe Smart Access Point comes with a PoEinjector kit for connecting to power over theEthernet port. The Smart Access Pointautomatically turns on as soon as it is connectedto a power source.Cautions:Use only the power adapter and PoE injectorthat came with the wireless AP.1. Insert one end of an Ethernet cable to theP+DATA OUT port on the PoE injector.2. Insert the other end to the LAN 1/PoEport on the Smart Access Point.3. Connect the power cord to the PoEinjector.4. Connect the power plug to a wall socket.